Table of Contents
Advertisement
[4.5]
Setting the communications environments
After the BHT is initialized, the interface port and communications parameters are set as listed in the
default table below. Do not access them unless necessary.
Interface port
Communications protocol
Communications parameters
for the IrDA interface port
TRANSMIT SPEED
PROTOCOL (Protocol options)
Listed below are the default communications parameters for the direct-connect interface.
Communications parameters
for the direct-connect interface port
TRANSMIT SPEED
PARITY BIT (Vertical parity)
DATA BIT (Character length)
STOP BIT (Stop bit length)
PROTOCOL (Protocol options)
Chapter 2 Getting Started the BHT and System Mode
Optical (IrDA interface port)
YMODEM
Defaults
115200 bps
SERIAL No.:
ON (Adds serial numbers to data
blocks.)
H. PARITY:
ON (Adds a horizontal parity.)
LINKUP TIME:
30 seconds
FIELD SPACE:
Ignore (Trim)
Defaults
115200 bps
None
8 bits
1 bit
SERIAL No.:
ON (Adds serial numbers to data
blocks.)
H. PARITY:
ON (Adds a horizontal parity.)
LINKUP TIME:
30 seconds
FIELD SPACE:
Ignore (Trim)
59
Advertisement
Chapters
Table of Contents
