2 ] Cu-311 - Denso BHT-300B User Manual

[ 2 ] CU-311

This section describes how to start communication with the host PC in System Mode (FTP).
(1) Turn the host PC on.
(2) Make sure that the AC adapter is plugged into a wall socket and the POWER LED is lit.
(3) Turn the BHT off and then put it on the CU-311.
(4) Turn the BHT on and start System Mode. Set up the TCP/IP (device) or FTP (FTP server IP address,
user ID, etc.). Refer to Chapter 2, Section 2.5.3, [4.9].
(5) On the host PC, initiate an FTP server program.
(6) To exchange data by FTP between the BHT and the host PC, select "FTP" on the SYSTEM MENU.
Refer to Chapter 2, Section 2.5.3, [ 7 ].
The BHT and the host PC
communication, the DATA LED
start communication
comes on; after completion of communication,
147
Chapter 5 Handling the
CU-311
Ethernet interface
AC adapter
with each other via the CU-311. Upon start of
CU-300 (Option)
it goes off.