Electronics
Earth Connections
To avoid damaging the vehicles electric and electronic components, the earths of any wiring
harness near the weld area must be disconnected. Position the earth of the welding machine
as close as possible to the weld area. If the mating faces of the parts to be welded are not
Accessible, use a GMAW plug weld in place of the original electrical resistance weld.
Earth studs on the front left-hand side
member.
Earth stud on the front right-hand
side member.
(5) Earth studs on
the Tunnel and
centre floor side
section.
Page 39
Earth studs on the left-hand front end side
cross member.
Earth stud on the bulkhead.
(6) Earth stud on the
left-hand rear quarter
lining.
(7) Earth stud on the
rear right-hand outer
wheel arch.
Technical Training Renault Fluence