Body
Anticorrosion points
Hollow body parts are to be treated from inside of the vehicle after painting and before re-
trimming. Blanking pieces are fitted to the injection points located beneath the vehicle. When
any work is carried out on the vehicle, plug all the points used for injection. Replace any
damaged or deformed blanking pieces with new ones.
Front impact
Replacing or repairing the front side member, the front side member closure panel and the
front sub frame mounting unit:
- injection of wax into points (9) , (10) , (11) and (12) .
Replacing the front side cross member or the front half unit:
- injection of wax into points (13) , (14) and (18) .
Side impact
Replacement or repair of the sill panel:
- protection of the join between the sill panel closure
panel and the sill panel reinforcement injection of wax into points (5) , (6) and (8) .
- protection of the join between the sill panel and the sill panel reinforcement injection of wax
into points (2) , (3) , (4) , (15) and (16).
Replacement of the centre floor:
- Protection of the join between the floor and the side member reinforcement injection of wax
into points (7).
Rear impact
Replacement of the complete rear side member:
- injection of wax into points (17) and (20) .
Replacement of the rear end panel:
- injection of wax into points (21) .
Replacement of the rear floor centre cross member:
- injection of wax into points (19)
Replacement of the front section of the rear floor:
- injection of wax into points (17) .
Page 23
Technical Training Renault Fluence