Pin Connections; Tlc7733; Description - Hitachi 42PMA225EZ Service Manual

42” plasma tv
Hide thumbs Also See for 42PMA225EZ:
Table of Contents

Advertisement

9.4.3. Pin connections

DIP Pin connections
NC: Not connected
Signal names
SDA
Serial data Address Input/Output
SCL
Serial Clock (I
V
Supply voltage
cc
V
Ground
ss
VCLK
Clock transmit only mode

TLC7733

9.5.
9.5.1.

Description

The TLC77xx family of micro power supply voltage supervisors is designed for reset control, primarily in
microcomputer and microprocessor systems.
During power-on, RESET is asserted when V
the circuit monitors SENSE voltage and keeps the reset outputs active as long as SENSE voltage
(V
)
I(SENSE)
remains below the threshold voltage. An internal timer delays return of the output to the inactive state to
ensure proper system reset. The delay time, t
t
= 2.1 x 10
x C
4
d
T
Where
C
is in farads
T
t
is in seconds
d
The TLC77xx has a fixed SENSE threshold voltage set by an internal voltage divider. When SENSE
voltage drops below the threshold voltage, the outputs become active and stay in that state until
SENSE voltage returns above threshold voltage and the delay time, t
In addition to the power-on-reset and under voltage-supervisor function, the TLC77xx adds power-down
control support for static RAM. When CONTROL is tied to GND, RESET will act as active high. The
voltage monitor contains additional logic intended for control of static memories with battery backup
during power failure. By driving the chip select (CS) of the memory circuit with the RESET output of the
TLC77xx and with the CONTROL driven by the memory bank select signal (CSH1) of the
microprocessor (see Figure 10), the memory circuit is automatically disabled during a power loss. (In
this application the TLC77xx power has to be supplied by the battery.)
The TLC77xxQ is characterized for operation over a temperature range of –40°C to 125°C, and the
TLC77xxI is characterized for operation over a temperature range of –40°C to 85°C.
Plasma TV Service Manual
2
C mode)
DD
, is determined by an external capacitor:
d
CO Pin connections
reaches 1 V. After minimum V
, has expired.
d
6
(. 2 V) is established,
DD
11/01/2005

Advertisement

Table of Contents
loading

Table of Contents