Mercedes-Benz S-Class Operator's Manual page 208

Telephone
206
X
To switch from the character bar to the
list: slide ZV the COMAND controller until
the character bar is hidden.
or
X
Select ¬.
X
To call a contact: select by sliding ZVÆ
or turning cVd the COMAND controller
and press W to confirm.
i
The phone book is also available via the
on-board computer (
Calling up contacts using the character
bar
X
Phone book: select
basic menu by sliding VÆ and turning
cVd the COMAND controller and press
W to confirm.
X
Address book: select
in the telephone basic menu by sliding
VÆ and turning cVd the COMAND
controller and press W to confirm.
X
Address Book
Select
confirm.
X
To select a character: select by sliding
ZVÆ or XVY the COMAND controller and
press W to confirm. Repeat this procedure
until COMAND automatically switches over
to the list.
You determine the first letter of the entry
you are looking for with the first character
you enter. If there are similar entries, the
next character which is different will be
displayed and offered for selection.
i You can also use the telephone number
keypad to enter characters.
Creating new contacts/changing
contacts
i
In certain countries, this function stops
being available from a vehicle speed of
more than approximately 3 mph (5 km/h).
As soon as the speed falls below
10 Only available with the "Change contact" function.
Y
page 383).
Name
in the telephone
Data/Connections
and press W to
I n f o r ma t i o n P r o v i d e d b y :
approximately 2 mph (3 km/h), the
function becomes available again.
i
You can enter address data directly into
the address book. If you store contacts in
the phone book, these are also saved in the
address book.
i
Automatically imported contacts cannot
be edited. They have to be saved first
before being copied to the COMAND
address book.
X
Call up the contact (
X
Options
Select by sliding VY and turning
cVd the COMAND controller and press
W to confirm.
X
New Entry
Select
confirm.
The input menu with data fields appears.
Entry mark (cursor)
:
Data field
;
Two-line character bar
=
B To select the language
10
Y page 205) .
Edit
or and press W to