Mercedes-Benz S-Class Operator's Manual page 179

Displaying real-time traffic reports
X
If necessary, switch to navigation mode
and show the menu (
X
Traffic
Select in the navigation system
menu bar by turning cVd the COMAND
controller and press W to confirm.
If you see the No traffic messages.
message:
This means that:
no traffic reports have been received yet.
R
no traffic reports are available.
R
X
To cancel the search: select Cancel.
X
To close the message window: select
OK.
If there are any traffic reports, a list is shown.
The content of the list varies depending on
whether route guidance is active or not.
List of traffic reports
X
To show the traffic report list: select
Display All Messages
the COMAND controller and press W to
confirm.
The list shows all the roads, areas or regions
for which traffic reports are available.
Y page 152).
by turning cVd
I n f o r ma t i o n P r o v i d e d b y :
State or province recognition
1
Road affected
2
i A traffic report may refer to an area or a
region, e.g. if visibility is impaired due to
fog.
X
To read a traffic report: select a road, an
area or a region.
X
To show a traffic report: select a road, an
area or a region and press W to confirm.
You will find an example of a traffic report
below.
X
To exit the list: slide XVY the COMAND
controller once or several times.
Example: traffic report
Country code
1
Road, area or region affected by traffic
2
reports
Direction
3
Report 1 of 8 for the road affected
4
Last exit/intersection before the affected
5
route section starts
Navigation
177
Z