Tools Required - Polaris MS4000 Service And Owner's Manual

TOOLS REQUIRED:

7/16 IN.
3/8 DRIVE
SOCKET
7/16 IN.
WRENCH
1. REAR MOUNTS
1.1 Remove existing rear mounts (part number 2874689) from the cab rear panel and install left and right mounts
from this kit in their place as shown in figure 1.1.
2. DOORS
2.1 Install doors onto hinges. Work the doors back and forth until the hinges are completely seated.
(NOTE: the hinges, and striker bolt can all be adjusted for proper engagement.)
2.2 Tighten all remaining bolts.
2.3 Install gas springs onto ball studs with the piston side toward the door.
CAUTION: FOR SAFE OPERATION, DO NOT DRIVE WITH DOORS OPEN. MAKE SURE DOORS
ARE CLOSED AND PROPERLY LATCHED WHEN DRIVING.
CARE AND MAINTENANCE
Check and tighten hardware after 40 hours of operation.
Periodically inspect and tighten hardware for the remainder of the unit's life.
Wash the painted surfaces of the unit with commercial automotive cleaning products.
Clean windows with glass cleaner.
POLARIS RANGER/UTV DOOR KIT (STEEL DOORS)
INSTALLATION INSTRUCTIONS
1/2 IN.
OPEN
OPEN
END
END
WRENCH
3/4 IN.
3/16 INCH
OPEN
ALLEN
END
DRIVE
WRENCH
3/8 DRIVE
Rear mount bolts.
Left side shown
FIG
68
3/8 DRIVE
RATCHET
.
1.1
REV. -
p. 2 of 3, Rev. C