Polaris MS4000 Service And Owner's Manual page 50

Technical Specifi cations
DIMENSIONS
Base 1 5/8" (4cm) x 2 1/4" (5.5cm), Height (including
removable protective cap)
2 1/2" (6cm), Brackets 1 1/4" (3.5cm) x 5/8" (1.5cm) x 1/8"
(3mm).
WEIGHT
Battery Brain 175gm, Accessories 280gm, Packaging 3gm;
Total weight 408gm (1lb).
CURRENT SPECIFICATIONS
Operational Current Consumption for type II & III After
disconnect: 3.8 Milliamps.
Operational Current Consumption for type I & IV After
disconnect: 0 Milliamps
Maximum Peak Amperage: 1100 Amps, for 15 consecutive
seconds.
Continuous Amperage Capacity: 250 Amps.
Disconnect Voltage Threshold: 11.8V
Disconnect Voltage Threshold for type IV RV: 10.5V
OPERATIONAL TEMPERATURE RANGE
-60°F (-51°C) to 200°F (90°C).
Battery Brain is made of non-combustible materials.
BATTERY SAFETY WARNING!
When working with lead acid batteries and accessories,
caution must be employed:
• Shield eyes. Do not open vent caps or puncture battery
casing in any way.
• Sulfuric acid can cause blindness and severe burns.
• Rinse hands and fl ush eyes with water immediately.
• Avoid sparks, fl ames and smoking.
PROPOSITION 65 WARNING
Battery posts, terminals, and related accessories contain
lead and lead compounds. Chemicals known to the State
of California to cause cancer and reproductive harm. Wash
hands after handling.
Battery Brain
GENERAL
The Battery Brain is installed on the positive (+) battery post
with the post clamp provided. The clip end of the black
ground wire is fastened to the negative (–) post clamp bolt.
HELPFUL HINT
The positive (+) bracket on the Battery Brain for the positive
(+) post clamp is on the same side of the Battery Brain unit
with "12V+" printed on it.
TOOLS REQUIRED
Tools required may vary based on your vehicle. The
most common tools are; Open-end 5/16", 9/16", 10mm,
12mm,14mm, or adjustable wrench. Standard and Phillips
screwdrivers.
REMOTE CONTROL USERS
Save a copy of the identifi cation number on the back of
your remote control. You will need it to order a replacement
if lost.
IMPORTANT NOTE
Before beginning installation, be sure your battery is
holding the proper charge. If your battery does not hold a
minimum charge, it may be at the end of its lifecycle. The
Battery Brain is designed to protect a properly functioning
or new battery. It cannot restore or repair a damaged
battery. If your vehicles battery shows any signs of physical
damage such as swelling, leaking or cracking, replace the
battery prior to installing Battery Brain.
IMPORTANT NOTE
Unless you are fully familiar with your vehicles electrical
system it is recommended that installation of this product is
performed by a certifi ed technician.
IMPORTANT NOTE
This product is not intended for Marine use and should
not be submerged in water. Units specifi cally designed for
Marine use are available, see www.smgy.net/batterybrain
for more information.
Battery Brain Kit includes
BATTERY BRAIN UNIT:
1. Manual "ON/OFF" Reset Control Knob under removable
protective cap
2. Positive (+) side of Battery Brain (side with writing) with
Butterfl y Connector
3. Black Ground Wire, attached to unit
4. White Antenna Wire, attached to unit (type II & III only)
50
Type IV Only-This unit has the same remote capacities as
the type III, but uses a push button (5) instead of a remote
control to change the setting of the Battery Brain with the
press of the button. The button can be mounted/concealed
anywhere in the vehicle and is connected to the Battery
Brain unit via a wire.
Type IV RV looks like the type IV model but is designed to
be connected to the utility/house/coach batteries in order
to avoid the deep cycling of full discharge and charging that
can prematurely end a batteries life.
Do not press the button while the engine is running. Mount
the push button in the desired location by tightening the nut
provided.