Special Tools; Torque Specifications; Wheel, Hub, And Spindle Torque Table; Front Hub - Polaris MS4000 Service And Owner's Manual

SPECIAL TOOLS

PART NUMBER
2872608
8700226
PU-48951

TORQUE SPECIFICATIONS

Wheel, Hub, and Spindle Torque Table

ITEM NUT TYPE
Aluminum Wheels
Lug Nut (1)
(Cast)
Steel Wheels
Flange Nut (2) 35 ft. lbs. (47 Nm)
(Black / Camo)
Front Spindle Nut
Rear & Middle
Hub Retaining Nut
#1
Aluminum Wheel
(LE Models)
90 ft. lbs. (122 Nm)
TOOL DESCRIPTION
Roller Pin Removal Tool
CV Boot Clamp Pliers
Axle Boot Clamp Tool
SPECIFICATION
90 ft. lbs. (122 Nm)
- 70 ft. lbs. (95 Nm)
- 110 ft. lbs. (150 Nm)
#2
Steel Wheel
(Standard Models)
35 ft. lbs. (47 Nm)

FRONT HUB

Hub Removal / Inspection

1. Elevate front end and safely support machine under
footrest / frame area.
CAUTION
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Wear eye protection when
removing bearings and seals.
2. Check bearings for side play by grasping the tire / wheel
firmly and checking for movement. Grasp the top and
bottom of the tire. The tire should rotate smoothly without
binding or rough spots.
3. Remove wheel nuts, washers, and wheel.
4. Remove the two brake caliper attaching bolts.
CAUTION: Do not hang the caliper by the brake line. Use
wire to hang the caliper to prevent possible damage to the
brake line.
FINAL DRIVE
7
7.3