Care And Maintenance - Polaris MS4000 Service And Owner's Manual

MODEL: POLARIS RANGER CAB KIT INSTALLATION INSTRUCTIONS
11. MOUNTING BRACKET
11.1 Lift the dump bed.
11.2 Using a 13/32" drill bit, and using the approximate center of the mounting
bracket slots as a guide, drill four (4) holes through the sheet metal on the ve-
hicle as shown in the enlarged view below (fig. 11.2).
11.3 Use four (4) 3/8" x 1" hex. head bolts, steel washers, and locknuts to secure
the mounting brackets to the vehicle (2 per side).
12. FINISHING TOUCHES
12.1 Install wiper motor per instructions included with the kit.
12.2 Install 5/16" plastic nut covers on all interior 5/16" locknuts.
12.3 At this point, to install doors, follow the instructions included in the vinyl door
kit (p/n 2874693).
Fig. 11.2
Drill 4 holes
(2 per side)

CARE AND MAINTENANCE

Check and tighten hardware after 40 hours of operation.
Periodically inspect and tighten hardware for the remainder of the unit's life.
Wash the painted surfaces of the unit with commercial automotive cleaning products.
Clean windows with glass cleaner.
Vinyl components should be washed with a mild solution of warm soapy water.
Clear vinyl can be easily scratched. Be careful cleaning frost or snow from windows.
Do not roll curtains in cold weather. The windows become stiff and may crack. Keep
windows clean.
drill here
65
REV. J
PAGE 6 OF 7