Engine Lubrication Specifications; Oil Pressure Test - Polaris MS4000 Service And Owner's Manual

ENGINE
Exhaust
1. Replace exhaust gaskets. Seal connections with high temp
silicone sealant.
2. Check to be sure all springs are in good condition.
Bleed Cooling System
NOTE: Follow coolant bleeding procedure outlined
earlier in this chapter
Engine Break-In Period
The break-in period for a Polaris RANGER engine is defined as
the first 25 hours of operation, or the time it takes to use 2 full
tanks of gasoline. No single action on your part is as important
as a proper break-in period. Careful treatment of a new engine
will result in more efficient performance and longer life for the
engine. Perform the following procedures carefully:
CAUTION
Use only Polaris PS-4 PLUS 2W-50 Synthetic
engine oil or an equivalent.
Never substitute or mix oil brands.
Serious engine damage and voiding of
warranty can result.
Do not operate at full throttle or high speeds for
extended periods during the first three hours of
use. Excessive heat can build up and cause
damage to close fitted engine parts.
1. Fill fuel tank with unleaded or leaded fuel which has a
minimum pump octane number of 87= (R+ M)/2.
2. Check oil level indicated on dipstick. Add oil if necessary
(Refer to Chapter 2, "Engine Oil Level" ).
3. Drive slowly at first to gradually bring engine up to
operating temperature.
4. Vary throttle positions. Do not operate at sustained idle or
sustained high speed.
5. Perform regular checks on fluid levels, controls and all
important bolt torques.
6. Pull only light loads during initial break-in.
7. Change oil and oil filter after break-in period at 25 hours.
3.20

Engine Lubrication Specifications

Capacity - Approximately 2 U.S. Quarts (1.9 l)
Oil Type - Polaris PS-4 PLUS 2W-50 Synthetic
Filter Wrench - PV-43527 or equivalent
- Oil Pressure Specification -
35-39 PSI @ 5500 RPM, Polaris 2W-50
Synthetic, Engine at operating temperature.

Oil Pressure Test

1. Remove blind plug/sender from left side of crankcase.
2. Insert a 1/8 NPT oil pressure gauge adaptor into the
crankcase and attach the gauge.
3. Start engine and allow it to reach operating temperature,
monitoring gauge indicator.
NOTE: Use only Polaris PS-4 PLUS 2W-50 Synthetic
Engine Oil.
Oil Pressure at 5500 RPM (Engine Hot):
Standard: 39 PSI
Minimum: 35 PSI
=