On-Hook Scan; Dualwatch - Icom IC-A110EURO Instruction Manual

3
SCAN OPERATION
■ ON–Hook scan
An ON–Hook scan (Hanger scan) stops when taking the mi-
crophone off its hanger (OFF–Hook) and resumes when
putting it back on the hanger (ON–Hook).
➥ Push [SCAN] to start scanning.
• When a signal is received, the scan pauses until the signal dis-
appears.
• The scan resumes 2 seconds after the signal disappears, un-
less you pushed [PTT] and transmitted.
• Take the microphone off the hanger to stop the scan.
• Put the microphone back on the hanger to resume scan-
ning.
When you take the microphone OFF Hook during the scan
operation.
• In VFO scan;
the scan stops on the last frequency that was scanned.
• In memory scan;
the scan stops on the last memory channel that was
scanned.
• In priority memory scan;
the scan stops on the priority channel.
NOTE: Be sure to connect the supplied microphone
hanger to the vehicle's ground for ON and OFF Hook mi-
crophone functions. (p. 12)
7

■ Dualwatch

Dualwatch monitors the priority channel while you are
receiving another channel (VFO or memory channel).
• If a signal is received on the
priority channel, dualwatch
pauses on the priority chan-
nel until the signal disap-
pears.
• To transmit on the selected
channel during dualwatch,
hold down [PTT].
See page 11 for details of the priority channel setting.
ï Operation
q Select the desired operating channel (VFO or Memory
channel).
w Hold down [PRI] for 1 second to start dualwatch.
'P' blinks during dualwatch.
e To cancel dualwatch, push [PRI] again.
250 msec. 5 sec.
VFO
frequency
Priority
or
channel
memory
channel