D Ci-V; Scan; D Scan Type; D Resume Timer - Icom IC-120 Full Manual

7
MENU MODE
SETTINGS group
■ Functions (Continued)

D CI-V

(May not be displayed, depending on the
transceiver's presettings.)
 CI-V address
To distinguish equipment, each CI-V transceiver has
its own Icom standard address in hexadecimal code.
The IC-A120/IC-A120E's default address is 92.
When 2 or more transceivers are controlled through a
PC at the same time, set a different address for each
transceiver.
 CI-V baud rate
Set the CI-V data transfer speed.
• 4800 BPS to 19200 BPS: Sets the data transfer
• AUTO:
 CI-V transceive
Turn the CI-V Transceive function ON or OFF.
• OFF: Turns OFF the function.
• ON: When you change a setting on one
transceiver, the same setting is automatically
changed on other connected transceivers.
speed to between 4800
bps and 19200 bps.
The baud rate is
automatically set
according to the data rate
of the controller.

■ SCAN

D SCAN TYPE

(May not be displayed, depending on the
transceiver's presettings.)
Select the scan type. When you push [SCAN], the
scan proceeds according to this setting.
• NORMAL: Push [SCAN] to start a Normal scan.
• PRIORITY: Push [SCAN] to start a Priority scan.

D RESUME TIMER

(May not be displayed, depending on the
transceiver's presettings.)
When a received signal disappears, the scan resumes
according to this setting. Set the Resume Timer to
between 3 seconds and 10 seconds.

D ON-HOOK SCAN

(May not be displayed, depending on the
transceiver's presettings.)
Set the On-Hook scan function (p.3-2) to ON or OFF.
• OFF: The On-Hook scan function is OFF.
• ON: The On-Hook scan function is ON.

D STOP/TX CH

(May not be displayed, depending on the
transceiver's presettings.)
Select the channel that On-Hook scan stops on when
you remove the microphone from the hook, and
the channel to transmit on when you push [PTT] in
Dualwatch operation.
• SCAN CH: The displayed channel is used as the
scan stop channel during an On-Hook
scan, and as the transmit channel.
• PRIORITY CH: The Priority channel is used as the
scan stop channel during an On-Hook
scan, and as the transmit channel.
7-6