Commissioning Report - Potterton Paramount two Installation, Operation & Maintenance Manual

Wall hung condensing boiler 30 – 115kw

Hide thumbs

Table Of Contents

Table of Contents

Commissioning report

11. Commissioning report

Wood Lane, Erdington

Birmingham B24 9QP

Telephone 08706 050607 Fax 08706 001516

REPORT No: ..........................................................

SITE ADDRESS: ...................................................

................................................................................

1.0

BOILER

1.1

Type:

1.2

No of Sections:

Boiler

1.3

No/Position:

1.4

Serial No:

1.5

Fuel:

N/Gas

2.0

BURNER

2.1

Type:

Standard

Flame

2.2

Detection

Probe:

2.3*

Control Box Type:

2.4

Electrical Supply:

2.5

Main Gas Valve Type & Size:

2.6

Pilot Gas Valve Type & Size:

2.7

Gas Train Serial Number:

3.0

BURNER SETTINGS

3.1

Main Burner Injector Size:

3.2

Pilot Burner Injector Size:

3.3

Are Burners & Injectors Clean?:

3.4

Kanthal Bars Fitted? (Modified & Ultimate only):

3.5*

Is the Probe of the Correct Type?

3.6

Electrode Settings as Manual?

4.0

PRE-COMMISSIONING CHECKS (See Note)

4.1

Is boiler house ventilation as per manual?

Electric supply fused, isolated & earth wire

4.2

attached?

4.3

Check external controls allow operation

Check boiler/system flooded and pumps

4.4

operational and any isolation valves open

4.5

Check gas available at burner

Check condensate trap fitted, filled and

4.6c

connected to drain with air break

4.7

Check gas meter sizing adequate

4.8

Check flue system clear

NOTE: It is the installer's responsibility to ensure that the boiler is correctly commissioned by a competent engineer and that this report is completed

and kept as a record. A commissioning service available from Potterton at the address listed on the back page of this manual. When a Potterton

engineer commissions, this completed report will be sent to the installer. It is the installers responsibility to action any points arising. Commissioning

by Potterton engineers is restricted to equipment of our supply. No responsibility is accepted for the on site assembly or installation of the equipment

unless specifically carried out by Potterton. The installer must ensure that the boiler is installed in accordance with the manufacturer's instructions

and all relevant BS Codes of Practice and Regulations (see manufacturers instructions for full details). Items 4.1 to 4.6 are related to the boiler

installation and as such these pre-commissioning checks should be carried out in the presence of the installer.

Potterton is a Member of the Boiler & Radiator Manufacturers Association (BARMA), and the terms of this Commissioning Document follow the

generally agreed conditions of the Association. Potterton, in line with its policy of continuous product development, reserves the right to alter and

amend this Document as is deemed necessary at any time.

Centre

LPG

Low NOx

Ultimate

UV Cell

Thermocouple

REPORT SENT TO