Remote Modem Dip Switch Settings (For Operation) - ACR Electronics PowerWatch Reference Manual

PowerWatch©
67
6. Change E1 back to E0, Q0 back to Q1 and send the setup string again.
(The other commands in this dialog box apply only to the computer station
modem.)
7. Disconnect the remote modem from your computer.
Next step:

Remote modem DIP switch settings (for operation)

Ó 2007, ACR Systems Inc.
5.3.5 Remote modem DIP switch settings (for operation)
Remote modem DIP switch settings
(for operation)
Previous step:
Choosing the remote modem setup string
When the modem is configured correctly you can change the DIP switch
settings to the remote settings.
Set the DIP switches to the remote settings. If you have a US Robotics
modem set the DIP switches to the settings in the table below.
REMOTE MODEM DIP SWITCH SETTINGS (US ROBOTICS)
DIP Switch Number
Switch Settings
1
2
3
4
5
6
7
8
If you have a make of modem other than US Robotics, check to see if the DIP
switch settings are different for the powerup modes listed in the table above.
The modem is now ready to be installed at the remote site.
Next step:
Configuring the computer station modem
Powerup Mode
Override DTR operation
Numeric result codes
Result codes disabled
Offline commands not echoed
Auto answer enabled
Normal CD operation
Load user defaults
AT command recognition
DIP
DOWN
DOWN
UP
DOWN
UP
UP
UP
DOWN
2007 ACR Systems Inc.