Table of Contents
Advertisement
1 Starting the NAUTICAST2
1.1 Initial Set Up of the NAUTICAST2 for operation
After installing the antennas and hardware the following User, Voyage related and Ship Settings
data needs to be entered. Upon Start-up (Applying power) enter the following information.
a) Enter MMSI Number - See paragraph 1.2 on entering information.
During the initial boot or after "factory settings" the user is asked to enter a valid MMSI
number. As long as this is not done, the system does not transmit. This appears as Alarm-ID
56 with the text "AIS: ENTER MMSI NUMBER".
b) Ship Settings Data - After initial entry of the Ship Settings Data any changes in the
information below should be edited accordingly. See Paragraph 1.3 on entering information.
•
Enter Call Sign
•
Enter Ships Name
•
Enter Length of Ship
•
Enter Beam of Ship
•
Enter Internal GPS antenna Position
•
Enter External GPS Antenna Position (If applicable).
•
Enter Ship Type
c) Voyage related Data – After initial entry of the Voyage related Data any changes in the
information below should be edited accordingly.
See paragraph 1.4 above on entering information.
•
Enter Cargo Type
•
Enter Draught
•
Enter Destination
•
Enter ETA
•
Enter Navigation Status.
d) Password – Service and User passwords see section 1.5
User Manual
LAT: N/A
SOG: N/A
LON: N/A
COG: N/A
IntN/A:
STOP
++++++++++++++++++++++++++++++++++++++++
Time 24:60 00/00
[!] ALARM ID:56
AIS: ENTER MMSI NUMBER
Please press OK to enter MMSI number!
Tx temporary suppressed
++++++++++++++++++++++++++++++++++++++++
00/00/00
24:60:60
! 7A 1T
4
Y1-03-0218 Rev A
Advertisement
Table of Contents
