Automatic Demonstration - JVC LYT1094-001A Instructions Manual

Automatic Demonstration

Automatic Demonstration takes place when "DEMO
MODE" is set to "ON" (factory-preset).
SET/SELECT Button
Power Switch
Lock Button
MENU Button
+, – Button
Sub Menu
SY ST M E
DE O M MO DE – OFF
O N
Automatic Demonstration starts when there is no
operation for about 3 minutes after the Power
Switch is set to "A" or "M" and no cassette is in
the camcorder.
Performing any operation during the
demonstration stops the demonstration
temporarily. If no operation is performed for more
than 3 minute after that, the demonstration will
resume.
"DEMO MODE" remains "ON" even if the
camcorder power is turned off.
To cancel Automatic Demonstration
1
Set the Power Switch to "M" while pressing down
the Lock Button located on the switch.
2
Open the LCD monitor fully, or pull out the
viewfinder fully.
3
Press MENU. The Menu Screen appears.
4
Press + or – to select "s SYSTEM", and press
SET/SELECT. The SYSTEM Menu appears.
5
Press + or – to select "DEMO MODE", and press
SET/SELECT. The Sub Menu appears.
6
Press + or – to select "OFF", and press SET/
SELECT.
7
Press + or – to select "BRETURN", and press SET/
SELECT twice. The normal screen appears.
NOTE:
Slide the lens cover down to see the actual changes
of the Automatic Demonstration activated on the
LCD monitor or viewfinder.
9
EN