Dubbing Still Images Recorded On A Tape To A Memory Card - JVC LYT1094-001A Instructions Manual

Dubbing Still Images Recorded On
A Tape To A Memory Card
Still images can be dubbed from a tape to a memory
card.
VIDEO/MEMORY Switch
Play/Pause Button
Power Switch
SNAPSHOT
Lock Button
Button
MENU Button
SET/SELECT
Button
(4/9)
+, – Button
1
Load a cassette. (
2
Load a memory card. (
3
Set the VIDEO/MEMORY Switch to "VIDEO".
4
Set the Power Switch to "P" while pressing
down the Lock Button located on the switch.
5
Set " COPY" to "ON". (
6
Press 4/9 to start playback.
7
At the point you want to dub, press 4/9 again to
engage Still Playback.
8
To dub the image, press SNAPSHOT.
The " " indication appears during
dubbing.
The selected image is stored in the memory
card.
NOTES:
If SNAPSHOT is pressed in step 8 when a memory
card is not loaded, the message "COPYING
FAILED" is displayed.
If an image recorded on the tape using "WIDE
MODE" ( pg. 37) is dubbed to a memory card,
the WIDE mode identifying signal is not dubbed
with it.
To use Playback Special effects with a video image
you wish to dub, perform up to step 8 using the
remote control (provided). (
Images are dubbed in 640 x 480 pixels.
EN
pg. 15)
pg. 16)
pg. 31, 40)
pg. 55)
53