Removing Valve; Installing Valve - Regency P36D-NG1 Owners & Installation Manual

5) Replace door on the stove
and check the seal.

REMOVING VALVE

1) Shut off the gas supply.
2) Remove the louvers (and bay door if it is
on).
3) Open the fl ush door and remove the door.
4) Remove the logs.
5) Remove the burner/grate assembly by
removing the two Phillips head screws and
then lift the burner assembly out.
Diagram 1: Remove the left and right screws
and then lift out the
burner/grate assembly.
6) Remove the rear log stand by removing the
2 screws.
screws
®
Regency P36D-1 Zero Clearance Direct Vent Gas Fireplace
7) Lift out the bottom brick panel.
8) Disconnect the inlet gas line. See diagram
2.
9) Disconnect the 2 TP wires and the 2 TH
wires from the valve.
10) Remove the 10 Phillips head screws securing
the valve tray assembly in place and then
lift the entire assembly out.
screws
11) Undo the pilot tube from the valve with a
7/16" wrench.
12) Undo the quick drop out thermocouple nut
Rear Log Stand
on the valve with a 9mm (metric) wrench.
13) Remove the Piezo igniter wire and push
button assembly.
14) Undo the "gas out" fl are nut with a 13/16"
wrench.
15) Undo the "gas out" fl are fi tting with an 11/16"
wrench.
16) Remove the 4 Phillips head screws from
Hint:
1) Attach the valve to the valve bracket with
2) Reconnect the "gas out" fl are fi tting with an
3) Reconnect the "gas out" fl are nut with a
4) Install piezo ignitor push button assembly
5) Reconnect the quick drop out thermocouple
6) Reconnect the pilot tube nut with a 7/16"
7) Scrape off the old gasket from the fl oor of the
8) Install a new gasket and reinstall the valve
Valve Tray Assembly
Note:
9) Reinstall the 10 hold down screws.
10) Hook up the 2 TP and 2 TH wires to the
11) Reinstall the bottom brick panel and the
12) Install Burner/grate assembly
13) Hook up the gas line and check for gas
14) Fire up the unit temporarily
15) Check the manifold pressure.
16) Reinstall the logs and brick panels as
17) Close the door and replace the louvers.
18) Fire up the unit again and check for proper
MAINTENANCE
the sides of the valve bracket and remove
valve.
If you are using black pipe, ensure
that there is a union by the valve,
otherwise removal will be almost
impossible.

INSTALLING VALVE

the 4 (m5x8 metric) screws provided.
11/16" wrench.
13/16" wrench.
and reconnect wire.
nut with a 9mm wrench.
wrench.
fi rebox and from the valve tray assembly.
tray assembly.
Failure to install a new gasket
may severely affect the appliance
performance.
appropriate connections on the valve.
front log stand.
leaks with a soap and water solution or a
gas leak detector. (Do not use open fl ame
for leak testing.)
needed.
fl ame appearance and glow on logs.
53