Motors; 7.10.1 Removing/Installing The Motor - Invacare ProntoM41 Service Manual

SERVICE MANUAL
7.10

Motors

WARNING!
Personal injury or damage may occur in case of repairing or servicing the wheelchair.
● After ANY adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely.
● ALWAYS turn the wheelchair power off before repairing or servicing the wheelchair.

7.10.1 Removing/Installing the motor

Note
Reverse this procedure to install the motor.
●
Remove the seat, as described in chapter 8.2.1.
●
Remove the front cover, as described in chapter 8.8.2.
●
Remove the right battery, as described in chapter 8.9.3.
●
Place two 5-inch blocks under battery frame to lift frame off the ground for ease in performing
this procedure.
●
Remove the drive wheel, as described in chapter 8.7.5.
●
Cut all tie-wraps securing the motor lead to the frame (not shown).
●
Remove the controller cover, as described in chapter 8.8.3.
●
Disconnect the motor lead connectors from the controller.
●
Unhook the spring from the frame and bracket, as described in chapter 8.8.5.
1 Screws
2 Locknut
3 Spacer
56
4 Swingarm 7
5 Motor 8
6 Spring 9
Invacare
Hook
Bracket
Frame
®
- PRONTO M41