Invacare ProntoM41 Service Manual page 54

SERVICE MANUAL
1 Black connectors
2 Posititve (+) battery terminal
cap
3 UI Battery
4 Negative (--) battery terminal
cap
5 Negative (--) battery cable
●
Connect battery cables to batteries terminals/posts (8) (11):
NEGATIVE (-) black battery cable (5) to NEGATIVE (-) battery terminal/post (11) .
POSITIVE (+) red battery cable to (7) POSITIVE (+) battery terminal/post (8).
●
Secure the battery cables/ring terminals to the battery terminals/posts, black to NEGATIVE (-)
and red to POSITIVE (+), with the provided 1/4-20 x 5/8-inch hex flange screw and hex flange
locknut. Securely tighten.
●
Verify all battery cables/ring terminals are correctly installed and securely tightened.
●
Slide terminal caps (2) (4) down battery cables (5) (7) and onto battery clamps.
●
Secure each terminal cap in place with a tie-wrap (13) (use tie-wraps 11-1/2-inches long).
●
Position the batteries into the wheelchair, as described in chapter 8.9.3.
Note
New battery (ies) MUST be fully charged before using, otherwise the life of the battery(ies) will be
reduced.
54
6 Red connector
7 Posititve (+) battery cable
8 Posititve (+) battery terminal
9 L-bracket with mounting
screw
10 Locknuts
®
Invacare - PRONTO M41
11 Negative (-) battery terminal
12 Mounting screw
13 Tie-wraps
14 Left battery
15 Black connector to controller
16 Right battery