Figure 41. Fastening The Chassis - Motorola XTS 2500 Basic Service Manual

chassis assembly.
3. Push down the latches on the connectors to hold the flex circuits to the main board.
NOTE: Be sure the concentric lever is not in place on the
frequency knob shaft when reassembling the chassis with
the front cover assembly.
4. Align the volume knob shaft and the frequency switch shaft with their respective
holes in the front cover. Slowly reassemble the chassis and front cover assemblies.
Slowly slide the volume knob and frequency switch shafts into their respective holes
in the front cover.
NOTE: Make sure the flex circuits are correctly folded in place.
Take special care to prevent pinching or excess binding
of these flexes.
5. Push the chassis assembly completely into the top of the front cover until it settles in
place.
NOTE: Be sure the O-ring is properly seated.
6. Press down at the bottom of the chassis until the chassis snaps into place in the front
cover.
7. Reassemble the concentric lever to the frequency knob shaft by aligning the
protrusions in the lever with the openings in the shaft. The triangular-shaped side of
the lever should point toward the back of the radio.
8. Reassemble the Teflon washer to the volume knob shaft. Reassemble the knobs, dust
cover, antenna, and battery.

Figure 41. Fastening the Chassis

Disassembly/Assembly
55