Ptt Disassembly; Figure 37. Speaker-Microphone Removal; Table 22.Ptt Disassembly - Motorola XTS 2500 Basic Service Manual

PTT Disassembly

NOTE: There are notches on the ends of the 13-pin printed
circuit backer board. If necessary, you can insert a small
screwdriver in one of the notches to pry the backer board
away from the front cover.
After the universal connector portion of the speaker-microphone flex circuit is
detached, the assembly can be completely removed. If it is necessary to replace the
speaker or the microphone, or both, do it while the flex circuit is removed from the
front cover.

Figure 37. Speaker-Microphone Removal

For this section, please refer to the Model III exploded view and parts list on page 35 for
part numbers and more information on the location of parts in the radio.
Exploded
View Motorola
Item Part Number
Number
1 1585746D03
4 1385149D01
5 7585959C01
1. If required, the PTT bezel and the PTT seal assembly can be disassembled using a
small screwdriver.
2. Remove the PTT bezel by pushing the snaps out at the top and pulling the bezel up
toward the top of the front cover so that the T-tab slides up and out.
3. The PTT seal can be easily lifted from the bezel without the use of tools.
Table 22. PTT Disassembly
Description
Cover, Front Assembly Kit
Bezel, PTT
Keypad, PTT/Side Controls
Disassembly/Assembly
51