Toaster Components - Holman QCSe-3 SERIES Installation And Operation Instructions Manual

CAUTION
CERTAIN SURFACES ARE EXTREMELY HOT DURING OPERATION AND CARE
SHOULD BE TAKEN WHILE USING THIS UNIT.
START UP
When the toaster has been plugged into a suitable outlet and power supply, the word OFF
will be displayed on the L.E.D. read out.
A. Press the ON/OFF button once to turn on the toaster. The toaster will now enter into
pre-heat and PREHT will be displayed (the elements will begin to glow but the conveyor and
fan motor will not turn on).
B. After one minute, the fan motor will turn on and the conveyor will begin turning at the
previously saved setting (for initial start up, the drive motor will operate at the factory default
setting).
C. After four minutes, the display will show the last used program selection i.e. TOAST,
BAGEL, MUFFIN or OTHER (for initial startup, TOAST will be the last program selected).
DAILY OPERATION
Check the power cord to insure that it is plugged into a proper outlet.
Press the ON/OFF button once to turn the toaster on.
Press the button a second time to turn the toaster off.
NOTE: When the toaster is turned off, the fan and conveyor motors will continue to run for
fi ve minutes. The words COOL and DOWN will be alternately displayed during that time.
After fi ve minutes, the word OFF will be displayed until the ON/OFF button is pressed again.
For units equipped with a POWER SAVER feature, the three operating modes are:
ON Unit has entered the pre-programmed level of power savings.
OFF Power Saver feature is turned off.
AUTO If the toaster has been idle for a pre-set period of time, the unit enters Power Saver
mode until one of the menu buttons has been pressed.
Once the toaster has been pre-heated, the menu buttons can be pressed to change to
TOAST, BAGEL, MUFFIN, or OTHER.
OPERATING HINTS AND SAFETY
Disconnect power to the unit with the ON/OFF button at the end of each day of operation.
Do not leave the unit in operation without an attendant.
Turn the POWER SAVER Switc h to Standby during idle periods. It will take only a few
minutes to regain operating temperature.
Do not leave the unit at high temperature when not in use or during idle periods. This will
cause food particles and grease fi lm to carbonize.

TOASTER COMPONENTS

LOAD UP
CRUMB TRAY
LCD DISPLAY
CONTROLS
6
FRONT
HIGH LIMIT RESET
AIR INTAKE FAN
POWER CORD