Setting Up Motion Only Recording; Setting Up Scheduled Recording - Digimerge DH100 Series Instruction Manual

Setting up Motion Only Recording

Step 1 of 2: Configure the Schedule for 24/7 motion recording:
1. Right-click in the main viewing window and click Main Menu>Schedule Setup (
2. Click on the desired schedule to configure on the left panel.
Click on the desired schedule
3. Deselect the "Enable Schedule Record" checkbox.
4. Select the "Enable Schedule Motion Detect" checkbox.
Select Enable
Schedule Motion
Detect
5. Configure the following:
• Start Time & End Time: Set the Start Time to 00:00 and the End Time to 24:00.
• Days of the week: Select every day of the week; do not select Holiday.
6. Right-click and click Yes to save your changes.
Step 2 of 2: Enable motion detection and disable Continuous Recording:
1. Enable motion detection for your cameras using the steps in "Enabling Motion Recording" on
page 23.
2. Ensure Continuous Recording is disabled.
• During Continuous Recording, the Record icon (
shown, right-click and click Record on/off (

Setting up Scheduled Recording

To set up Scheduled Recording, create separate schedules for Continuous Recording, motion
detection, and alarm sensor recording using the instructions in "SCHEDULE SETUP" on page 30.
Please note you will have to enable motion detection on your cameras to use motion detection.
Setting up Motion Recording
)appears in each channel. If the icon is
).
).
25