Mic/Audio2 - Panasonic AJ-SDX900E Operating Instructions Manual

CONTENTS
Chapter 7 Menu description tables
7-8-6

MIC/AUDIO2

Variable
Item
range
FRONT MIC ON For selecting the phantom power supply for
POWER OFF the front microphone.
REAR MIC POWER ON For selecting the phantom power supply for
OFF the rear microphone.
AUDIO OUT ON For setting the audio output circuit.
OFF OFF: The power to the output circuit is shut
ON: The signals of the audio output circuit
MONITOR SELECT STEREO For selecting the format of the signals to be
MIX output to the monitor.
FRONT MIC LEVEL –40dB For selecting the input level of the front
–50dB microphone.
REAR MIC CH1 –50dB For selecting the input level of the rear
LVL –60dB microphone.
REAR MIC CH2 –50dB For selecting the input level of the rear
LVL –60dB microphone.
REAR LINE IN LVL 0dB For selecting the rear line input level.
+4dB
AUDIO OUT LVL 0dB For selecting the rear audio output level.
+4dB
HEADROOM 18dB For setting the headroom (reference level).
20dB
WIRELESS WARN ON For selecting whether or not to output
OFF warnings when the reception of the wireless
receiver is poor.
The underlining in the variable range column indicates the setting in the preset mode.
98
Remarks
down, and the signals of the circuit are
not output.
are output.
7-8-7 TC/UB
Variable
Item
range
UB MODE USER For selecting the UB mode.
TIME USER:
DATE
EXT TIME:
TCG
FRM RATE DATE:
REGEN
EXT:
TCG:
FRM RATE: Selects the same camera shooting
REGEN: Reads the value recorded on the
TCG SET HOLD ON For selecting ON or OFF for the function that
OFF without fail uses what was previously set as
the TCG value for recording when the TCG
value had been set before the power was
turned off and recording was then performed
after the power was turned back on again.
FIRST REC TC REGEN For selecting whether or not to regenerate the
PRESET time code as the value on the tape during the
first recording after the power was turned on,
the cassette was inserted or a playback or
search operation was performed.
P.OFF LCD ON For selecting whether or not to set the LCD's
DISPLAY OFF time code and display its count while the
power is off.
ON: The time code can be set and
OFF: While the power is off, the power to the
TC OUT TCG For selecting the TC OUT output.
TCG/TCR TCG:
TCG/TCR: The time code generator value is
Remarks
Selects the UB value set in the
LCD section.
Selects the local time (hour,
minute, second).
Selects the local date and time
(last 2 digits of year, month, date,
hour)
Sets the UB from the TC-IN as the
slave. The user value is retained if
no value can be read.)
Inputs the TCG value unchanged.
data (frame rate, etc.) as the
VAUX UB (VITC UB).
tape and then continues to record
from that value.
displayed even while the power is off.
LCD section is turned off, and the time
code can be neither set nor displayed.
The time code generator value is
always output.
output with the E-E setting and the
time code reader value is output with
the V-V setting.