Example Of Pin-Code Personalization - Gemini 953 Installation And Use Manual

10.0 - EXAMPLE OF PIN-CODE PERSONALIZATION

To better understand how to set up the PIN-CODE, please refer to the example
below.
The following customized PIN-CODE 2-3-4-1
Turn off the alarm
Connect the BROWN/GREEN
wire to ground.
BROWN/GREEN
NEGATIVE
Turn the ignition key in "ON" position
Key in
The LED installed on the vehicle will light up for one seconds
During this time period, press both buttons on the remote control.
The system will emit two acoustic signals and then it will light the LED.
0.5
Sec.
Remove from negative the
BROWN/GREEN wire.
BROWN/GREEN
NEGATIVE
will be entered.
system .
Open the saddle of the vehicle if the
safety button is fitted.
.
"ON" position
Boop Fixed
light
Boop
C lose the saddle of the vehicle if the
safety button is fitted .
Push both remote control buttons at the same time.
The LED will go off.
Turn the ignition key in "OFF" position
After four seconds have passed, the LED will begin a series of nine flashes.
Turn the ignition key in "ON" when we intends to memorize the first
figure of the new PIN-CODE.
Key in "ON"
position
After four seconds have passed, the LED will begin a new series of nine
flashes.
Repeat the operations described above to insert the second number.
Key in "ON"
position
Repeat the same operations described above to insert the other two numbers.
When you have finished inserting the fourth number of the PIN-CODE, the
system will automatically exit the procedure and it will confirm the
termination with two low tone acoustic signals and one high tone signal
Key in
Last
"ON"
number
position
LED
off
.
Key in "OFF"
position
Key in "OFF" LED
position off
Key in "OFF" LED
position off
.
Key in
Boop
"OFF"
Boop
position
Beep