Extra Functions Programming - Gemini 953 Installation And Use Manual

28.0 - EXTRA FUNCTIONS PROGRAMMIG
In this section we describe the procedure to perform in case you want to
activate or deactivate one of the extra functions.
Please ALWAYS activate and deactivate the alarm system before
beginning the programming procedure.
After reading point 4, follow the instructions as reported in the following page,
where the extra functions and their activation are described.
1
With the system disabled, lift up the seat
If the seat/top case button has
not been installed on the vehicle,
ground the GREEN/BROWN wire.
2
Turn the ignition key to "ON"
3
Turning the ignition key to "ON" position, the
LED will light up for about one second.
Warning: o
4
While the LED is "ON", push the two buttons
simultaneously on the remote control.
The alarm system will confirm that the
programming has been enabled
and will cause the LED to light up
steadily two acoustic signals,
the first one in a low-tone beep, and second
PAG.18
(or open the trunk).
Once terminated the
programming operations,
unground this wire.
position.
nly during this period you can
proceed with step 4.
in an high-tone bee.
When step 4 has been done, i.e. both buttons pushed simultaneously on the
remote control, the actual programming procedure will start.
FUNCTION
ENABLING
Push the button
N. 1 to enable
the function
Button N.1: ENABLE
ACOUSTIC SIGNALS
(enabled by Gemini)
Button N.2: DISABLE
Button N.1: ENABLE
PANIC ALARM
(enabled by Gemini)
Button N.2: DISABLE
Button N.1: ENABLE
SHOCK SENSOR
(enabled by Gemini)
Button N.2: DISABLE
Button N.1: ENABLE
PASSIVE ARMING
(disabled by Gemini)
Button N.2: DISABLE
Button N.1: ENABLE
ANTI-HIJACKING
(disabled by Gemini)
Button N.2: DISABLE
Button N.1: ENABLE
PRE-ALARM
(disabled by GEMINI)
Button N.2: DISABLE
Button N.1: ENABLE
SYSTEM SELF-REARMING
(disabled by Gemini)
Button N.2: DISABLE
FUNCTION
DISABLING
Push the button
N. 2 to disable
the function
QUIT PROGRAMMING
PAG.19