Acoustic And Optic Signalling; Remote Controlled Panic Alarm; Shock Sensor; Passive Arming - Gemini 953 Installation And Use Manual

4.0 - DESCRIPTION OF THE EXTRA FUNCTIONS
The table below shows the programmable functions.
The manufacturer supplies the system with some of these functions disabled
(in order to achieve a good trade-off between ease and completeness of use)
being the shock sensor regulated at the minimum of the sensibility.
Factory setting
Function
Acoustic signals
Panic alarm

Shock sensor

Passive arming

Anti-hijacking procedure
Pre-alarm
System self-rearming

4.1 - ACOUSTIC AND OPTIC SIGNALLING

In the different usage conditions, the alarm system signals the current
operation or the alarm memory.
This is done using the turn signals an the LED for the optical signals and using
the siren for the acoustic signals (the last one can be disabled)
FUNCTIONNING
During the stages of activation, deactivation, alarm memory, function
programming and learning of new devices, the alarm will produce specific
acoustic and optic signals in order to show which function is being run.
Optic signallings concern either LED or turn signals.
The acoustic signals can be high-tone or low-tone.

4.2 - REMOTE CONTROLLED PANIC ALARM

It allows to generate an alarm condition by pressing button N. 2 (smooth) on
the remote control.
The panic signals can be as many as desired, but a minimum 5-second interval
must occur between two consecutive signals.
FUNCTIONNING
P ressing button N. 2 on the remote control will activate the siren and the
direction indicators for about 30 seconds.
To deactivate the panic alarm, just press again button N. 2 on the remote
control.
This alarm signalling can be activated indifferently of the system status
(activated/deactivated) .
The system may generate an alarm condition caused by a shock or a shifting of
the vehicle The shock sensor is buil in the alarm and is adjustabl
,
I n armed state, if the vehicle is hit or shifted, the sensor included in the alarm
system will detect this anomaly and generate an alarm
Status
This function allows the user to leave the vehicle sure that the alarm system
Enabled
protection arms itself automatically
Enabled
Enabled
Disabled
Once the engine is switched off, the system automatically activates the
Disabled
passive arming.
Disabled This will be signalled by one turn signals flash, two LED flashes and two siren
Disabled high-tone beeps
After 35 seconds the system will activate steadly, signalling the operation with
a single flash of the turn signals, two acoustic signal and the lighting up of the
LED (with a steady light).
The procedure can be interrupted, by turning on the ignition switch within 35".
If the trunk or the seat are open, the passive arming time will be interrupted,
. until the trunk or the seat closing
This function ensures a sort of protection against criminals when a theft
attempt happens while the vehicle is in use.
The function indeed allows to activate the system while stopping the vehicle
with the ignition key switch on and the engine running
With the ignition key switch on, it is possible to activate the anti-hijacking
function in the following ways
!
!
!
Once enabled the anti-hijacking function, the remote controls won't work
anymore.
4.3 - SHOCK SENSOR
.
FUNCTIONNING
4.4 - PASSIVE ARMING
.
F UNCTIONNING
.

4.5 - ANTI-HIJACKING FUNCTION

FUNCTIONNING
:
B y pressing button N. 1 on the remote control
B y pressing button N. 2 on the remote control
By inserting the electronic key in the receptacle
CAUTION
The activation of the anti-hijacking function will be signalled
by the system with two rapid flashes of the turn signals
and a steady LED.
e.
.
.
.
.
.