Learning Of New Devices (With Ground Wire); Learning Of New Devices (Without Ground Wire) - Gemini 953 Installation And Use Manual

26.0 - LEARNING OF NEW DEVICES
(BY BROWN/GREEN WIRE GROUND CONNECTION)
The system is supplied with two remote controls and an electronic key, but
saving to memory or replacement of electronic keys or radio controls could be
necessary .
To perform these steps, follow the procedure below, keeping in mind that the
passive arming function MUST be disabled
!
Disarm the system with a remote control or an electronic key.
!
Lift up the seat or open a top case or, in case the perimeter protection
button is not installed, ground the BROWN-GREEN wire
!
I nsert the saving to memory connector with button into the specific
connector; you can recognize it by the connector's yellow colour or the
connector's yellow sheath .
!
P ress and hold the above-mentioned button
!
Turn the ignition keiy in "ON" position.
!
Two flashes of the turn signals and two acoustic signals, one loud tone and
the other acute tone, will indicate that new devices learning procedure has
been started.
!
Release the provost push-button.
!
P ress one of the buttons on the remote control to be recognized or insert
the electronic key in the receptacle .
!
One flash of the turn signals and one acute tone acoustic signal will
indicate the new control device learning
!
In case of other devices to be saved to memory, press and release again
the saving to memory button, press the radio control button or put the
electronic key in its receptacle .
!
Turn the ignition key to "OFF" when the device saving to memory
procedure is over. he T system will notify the quitting from the program
mode with a low-tone beep and a single flash of the direction indicators
!
Close the seat or the trunk of the vehicle or remove the BROWN/GREEN
wire from ground, if a perimeter protection button has not been mounted
CAUTION
Storing memory is for 8 devices.
They can be remote controls, electronic keys or both of them.
If you store an extra device, it will automatically delete the first one
installed (position one of the alarm system memory).
PAG.16
.
.
.
.
.
.
27.0 - LEARNING OF NEW DEVICES
(WITHOUT BROWN/GREEN WIRE GROUND CONNECTION)
The system is supplied with two remote controls and an electronic key, but
saving to memory or replacement of electronic keys or radio controls could be
necessary .
To perform these steps, follow the procedure below, keeping in mind that the
passive activation function MUST be disabled
!
Disarm the system with a remote control or an electronic key.
!
With the system being disarmed, urn the ignition key to t
!
The status LED stay on for one second; during this period, push both
buttons of the remote control or insert the electronic key into the specific
receptacle.
!
Two flashes of the turn signals and two acoustic signals, one loud tone and
the other acute tone, will indicate that new devices learning procedure has
been started.
!
P ress one of the buttons on the remote control to be recognized or insert
the electronic key in the receptacle.
!
In case of other devices to be saved to memory
p ress one of the buttons on the remote control to be recognized or insert the
electronic key in the receptacle .
!
T urn the ignition key to "OFF", when the device saving to memory
procedure is over.
!
The system will notify the quitting from the program mode with a low-tone
beep and a single flash of the direction indicators
CAUTION
Storing memory is for 8 devices.
They can be remote controls, electronic keys or both of them.
If you store an extra device, it will automatically delete the first one
installed (position one of the alarm system memory).
.
"ON".
, wait for two seconds and
.
PAG.17