Table Of Contents - Gemini 953 Installation And Use Manual

UK
CONTENTS
1.0 - PRELIMINARY ADVICE
USER MANUAL
2.0 - ALARM SYSTEM CONTROL DEVICES DESCRIPTION
2.1 - Remote control
2.2 - Electronic key
3.0 - SYSTEM OPERATION WITH BASIC CONFIGURATION
3.1 - Arming
3.2 - Trunk open or seat lifted-up signalling
3.3 - Neutral time
3.4 - Siren exclusion
3.5 - Shock sensor exclusion
3.6 - Armed condition
3.7 - Alarm
3.8 - L imiting the acoustic signal
3.9 - Neutral time between two alarm signals
3.10 - System disarming without alarm memory
3.11 - System disarming with alarm memory
4.0 - EXTRA FUNCTIONS DESCRIPTION
4.1 - Acoustic and optic signalling
4.2 - Remote controlled panic alarm
4.3 - Shock sensor
4.4 - Passive arming
4.5 - Anti-hijacking function
4.6 - Pre-alarm
4.7 - System self-rearming
5.0 - SLEEP MODE ACTIVATION/DEACTIVATION
6.0 - HAZARD SIGNALLING
7.0 - USE AND MAINTENANCE
8.0 - SYSTEM UNLOCK PROCEDURE BY PIN-CODE
9.0 - XAMPLE E OF SYSTEM UNLOCK BY PIN-CODE
10.0 - EXAMPLE OF PIN-CODE PERSONALIZATION
11.0 - REMOTE CONTROL BATTERIES REPLACEMENT
12.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE)
DIRECTIVE
13.0 - WARRANTY CONDITIONS
CONTENTS
INSTALLER MANUAL
14.0 - INSTRUCTIONS FOR ALARM SYSTEM INSTALLATION
15.0 - TECHNICAL DATA
16.0 - CONTROL UNIT POSITIONING
17.0 - ACCESSORIES POSITIONING
17.1 - Receptacle for electronic key and LED
17.2 - Perimetral push-button (optional)
18.0 - C ONTROL UNIT SEALING
19.0 - SUMMARY REPORT FOR THE ELECTRICAL CONNECTIONS
20.0 - ELECTRIC DIAGRAM
21.0 - ENGINE IMMOBILISATION CONNECTING DIAGRAM (ground wire)
22.0 - ENGINE IMMOBILISATION CONNECTING DIAGRAM (cut wire)
23.0 - EXAMPLE OF ENGINE IMMOBILISATION CONNECTION WITH
SPECIFIC WIRING HARNESS
24.0 - ELECTRIC AL CONNECTIONS WITH SPECIFIC WIRING
HARNESS
24.1 - Engine immobilisation connections
24.2 - Turn signals connections
24.3 - Ground connection
24.4 - Receptacle for electronic key with built-in LED
25.0 - INSTRUCTION FOR DIODE APPLICATION
26.0 - LEARNING OF NEW DEVICES (with ground wire)
27.0 - LEARNING OF NEW DEVICES (without ground wire)
28.0 - EXTRA FUNCTIONS PROGRAMMING
29.0 - EXAMPLE OF PROGRAMMING
30.0 - SHOCK SENSOR ADJUSTMENT
31.0 - EXAMPLE OF SHOCK SENSOR ADJUSTMENT