Electronic Key; System Operation With Basic Configuration; Arming; Neutral Time - Gemini 953 Installation And Use Manual

2.2 - ELECTRONIC KEY

The electronic key can be considered a kind of "simplified remote control".
As a matter of fact, in emergency situations (e.g. a failure in the remote
control), it can activate and deactivate the alarm, or activate and deactivate the
anti-hijacking function (if previously programmed).
To use the electronic key, simply put it on the receptacle, and join the metallic
contacts.
The receptacle also incorporates the alarm system status LED
Electronic key
Electronic key
Example of receptacle positioning on the vehicle dashboard.
Pressing the (dotted) button #1 on the remote control or inserting the electronic
key into the receptacle will activate the system.
This action is indicated by one long flashing of the turn signals, two short
acoustic signals and the permanent turning on of the LED
.
During alarm system activation, should the seat or the trunk be opened, the
E xample of receptacle
system will signal the failure by means of a low-tone signal after the alarm
positioning on the vehicle
arming signalling.
plastic side cover .
In any case the system will be activated and, at the end of the "neutral time", an
alarm condition will be generated
When the activation signals are finished, the system goes in standby or
neutral-time condition, which is signalled with a steady-light LED.
This time duration is about 20 seconds.
The engine immobilization function and the connectors for optional modules
are already active.
D uring the first 4 seconds
by simply pressing (smooth) button
N. 1 remote control push-button pressure, system arming).
Siren exclusion will be signalled by a short flashing of the turn signals
When the siren is
only visual signals will be active, i.e. with flashing of the turn signals, but
D uring the first 4 seconds of neutral time, it is possible to exclude the built-in
shock sensor functionning.
To do this, you must just put the electronic key into the specific receptacle, after
the alarm system has been activated.
The exclusion is bound to a single arming cycle and will be indicated by a short
flashing of the status LED
3.0 - SYSTEM OPERATION WITH
BASIC CONFIGURATION

3.1 - ARMING

3.2 - TRUNK OPENED OR LIFTED-UP SEAT SIGNALLING
.

3.3 - NEUTRAL TIME

3.4 - SIREN EXCLUSION

of neutral time, the alarm siren can be deactivated,
N. 2 on the remote control
CAUTION
excluded , the alarm signals will
the engine immobilization function will still work.
The siren sound exclusion is bound to the single arming cycle

3.5 - SHOCK SENSOR EXCLUSION

.
.
(obviously after
.
be change d; i ndeed
.