Pre-Alarm; System Self-Rearming; Sleep Mode Activation/Deactivation; Hazard Signalling - Gemini 953 Installation And Use Manual

20 seconds after the activation, the system will immobilize the vehicle's
engine; two seconds later the siren will be activated at high volume and the
direction indicators will start blinking repeatedly.
This signalling will continue for a minute and, after this time, the siren will be
deactivated; the turn signals will continue blinking until the anti-hijacking
function is disabled.
To deativate the function insert the electronic key in the receptacle

4.6 - PRE-ALARM

In alarm condition, this implies the activation of the siren for just 2,5 seconds
(first 3 alarm cause only) rather than the standard 30 seconds.
This considerably reduces power consumption while preserving the vehicle's
battery, and it reduces the environmental acoustic pollution
FUNCTIONNING
When the system is activated, providing an alarm condition is generated (i.e.
the vehicle is accidentally hit), the siren will be activated for about 2,5 seconds.
This condition of pre-alarm will be activated for the first 3 alarm causes.
Indeed, from the fourth cause on, the siren will be activated for about 30
seconds.
The alarm cycles will be reset every time the alarm is deactivated or when the
panic alarm is activated .
4.7 -

SYSTEM SELF-REARMING

This function protects the vehicle in case the system would be unintentionally
deactivated .
FUNCTIONNING
The system is activated by the user, then unintentionally deactivated (e.g. the
relevant button on the remote control is pressed).
The user, unconscious about this, will leave the vehicle unprotected, although
being sure of the contrary.
35 seconds after this unintentional deactivation, the alarm will automatically
reactivate, signalling this with the standard acoustic and optical signals

5.0 - SLEEP MODE ACTIVATION/DEACTIVATION

When the vehicle is not used, it is possible to switch completely off the alarm
system (sleep mode) in order to reduce the battery charge consumption.
To activate this function, proceed as follows:
!
Turn the ignition key to "ON" position; the LED will light for about one
second.
.
!
After the LED flash put the electronic key into the receptable, within 4
seconds n acoustic signal will indicate that the system is turned off.
!
Turn the ignition key of the vehicle to "OFF" position.
!
To re-activate the alarm, turn the ignition key of the vehicle to "ON" and
"OFF".
.
The hazard signalling is useful when you want to park the vehicle, being the
vehicle engine off and the turn signals on.
To activate/deactivate this function, proceed as follows:
!
Switch off the engine, by turning the ignition key of the vehicle to "OFF".
!
Turn the ignition key to "ON" position; the LED will light for about one
second.
!
During this period, push the button N.1 of the remote control.
!
Turn the ignition key to "OFF"; the turn signals will start flashing.
!
To deactivate the turn signals flashing you must just turn again the ignition
key to "ON" (and eventually to "OFF"), or arm and disarm the system.
Please note that the alarm system is still an electronic device, so must be
handled carefully.
The following are simple hints which are useful if you want to prevent device
damage because of an improper use
.
!
Do not clean the control unit with water but only use a damp cloth
!
Do not use power supply voltages which are different than those specified
by the factory
!
I f the motorbike is cleaned with a washing machine, be careful not to
directly expose the alarm system to the water jets
Gemini Technologies S.p.A. is not responsible for damages to the system
; a

6.0 - HAZARD SIGNALLING

7.0 - USE AND MAINTENANCE

.
.
! WARNING
in case of an improper use of it.
.
.