Craftsman 137.415020 Operator's Manual page 42

. Before starting the table saw, lower
the blade and riving knife assembly
to the down position.
2. Remove the blade guard assembly
and anti-kickback pawls assembly
for non-through cut.
3. Use the featherboard () with
C-clamps (3) to fasten the workpiece
securely.
4. Mount the auxiliary fence (4) with
C-clamps.
5. Use the push block (2) to move the
workpiece.
NOTE: Mount the featherboard
to table as shown, so the leading
edges of featherboard will help
workpiece complete cutting.
Fig. bb

3
Non-through Cut
4
2
DADO CUTS (FIG. cc, dd)
WARNING
!
● Only Stackable dado blades can
be used on this saw.
● DO NOT use Adjustable or
Wobble type dadoes.
● The maximum dado cut width is
13/16 in.
● Do not use a dado with a diameter
larger than 8 in.
NOTE: An dado insert plate (part
number 0K not included) is
required for this procedure.
. Remove the table insert, saw blade,
anti-kickback pawl assembly, blade
guard assembly and riving knife
assembly for dado cuts ONLY.
Reinstall and realign blade guard
for all through-sawing operations.
Install a dado not exceeding 8 in. in
diameter and 3/6 in. in width
2. Install the dado table insert making
sure that the rear of the insert is
flush with the table. If the dado insert
is not flush with the table, adjust the
two bolts on the insert with a 4 mm
hex wrench until it is parallel with the
table.
3. Instructions for operating the dado
is packed with the separately
purchased dado set.
4. The arbor () on this saw restricts
the maximum width of the cut to
3/6 in.
5. It is not necessary to install the
outside flange (2) before threading
on the arbor nut (3) for the maximum
3/6 in. dado cuts. Make sure that
the arbor nut (3) is tight, and that at
least one thread of the arbor sticks
out past the nut.
6. Use only the correct number of
round outside blades and inside
chippers as shown in the dado
set's instruction manual. Blade/
chippers must not exceed 3/6 in.
total in width.
42 42