Craftsman 137.415020 Operator's Manual page 38

5. Attached the C-clamps (5) to secure
the featherboard to the edge of the
table.
Fig. SS
4
5
AUXILIARY FENCE (FIG. TT)
Making the base:
● Start with a piece of 3/8 in. plywood
at least 5-/2 in. wide or wider and
2 in. long or longer.
● Cut the piece to shape and size as
shown.
Making the side:
● Start with a piece of 3/4 in.
hardwood at least -3/4 in. wide or
wider and 2 in. long or longer.
● Cut the piece to shape and size as
shown.
Putting it together:
● Fasten the pieces together with glue
and woodscrews.
WARNING
!
Make sure the screw heads do
not stick out from the bottom of
the base, they must be flush or
recessed. The bottom must be flat
and smooth enough to rest on the
saw table without rocking.

3
2
Fig. TT
The edge must be
parallel with the face
PUSH BLOCK
Use for ripping operation when the
workpiece is too narrow to use a push
stick. Always use a push block for rip
widths less than 2 inches.
MAKE A PUSH BLOCK (FIG. UU)
Making the base:
● Start with a 3/8 in. plywood at least
5-/2 in. wide or wider and 2 in.
long or longer.
● Cut the piece to shape and size as
shown.
Making the handle:
● Start with a 3/4 in. hardwood at least
5 in. wide or wider and 7 in. long or
longer.
● Cut the piece to shape and size as
shown.
Making the bracket:
● Start with a 3/8 in. wood at least
3/8 in. wide or wider and 2-/2 in.
long or longer.
● Cut the piece to shape and size as
shown.
Putting it together:
● Fasten the base and handle together
with glue and woodscrews.
38 38
3/8 in. thick plywood base
21 in