Table of Contents
Advertisement
ADDITIONAL BLADE
ADJUSTMENTS (FIG. W)
. If the front and rear measurements
are not the same, remove the
combination square and loosen the
four adjusting screws () on the top
of the table about a half turn.
2. Cover the blade with a folded piece
of cardboard to protect your hands.
Move the blade and motor mounting
rod carefully to the left or right as
much as needed to align the blade
correctly.
3. Tighten the four screws () and
re-measure, as described in steps 4
to 8 in the prior section.
4. If sufficient adjustment cannot be
made by the four adjusting
screws (), then also loosen the two
adjusting screws (2) and repeat all
previous steps. Loosen these screws
only if necessary as they are set for
accurate 90° and 45° settings.
5. Recheck the blade clearance making
sure that the blade does not hit the
table insert or other parts when at
the 90° and 45° settings.
6. Re-tighten all four adjusting
screws () and reset the 90° and 45°
setting as stated on page 3.
Fig. W
2
BLADE GUARD AND ANTI-
KICKBACK PAWL ASSEMBLY
WARNING
!
To avoid injury from an accidental
start, make sure the switch is in
the OFF position and the plug is
disconnected from the power source
outlet.
● When installing the blade guard,
cover the blade teeth with a piece
of folded cardboard to protect
yourself from possible injury.
● Never operate this machine
without the blade guard in place
for all through sawing operations.
Installing the anti-kickback pawl and
blade guard assembly (Fig. X, Y, Z)
. Make sure the blade is elevated to
its maximum height and the bevel is
set at 0°. Make sure the bevel lock
knob is tight.
2. Raise the riving knife () to its
highest position (through cut
position). Take the anti-kickback
pawl assembly (2) and lift up the
locking lever (3) located on the top.
(Fig. X)
3. Place the front of assembly into the
slot (4) on the riving knife () and
move downward, making sure the
assembly is engaged in the slot (4).
Push down on the locking lever (3)
to lock. (Fig. X)
Fig. X
Loosen
2
27
27
3
4
Hide quick links:
Advertisement
Table of Contents
