Table of Contents
Advertisement
BLADE TILTING SCALE INDICATOR
(FIG. II)
. When the blade is positioned at 90°,
adjust the blade tilting scale indicator
to read 0
on the scale.
°
2. Loosen the holding screw (),
position the pointer over 0° and
tighten the screw ().
NOTE: Make a trial cut on scrap
wood before making critical cuts.
Measure for accuracy.
Fig. II
BLADE PARALLEL TO THE MITER
GAUGE GROOVE (FIG. JJ)
WARNING
!
This adjustment was made at the
factory, but it should be rechecked
and adjusted if necessary.
WARNING
!
To prevent personal injury:
● Always disconnect plug from the
power source when making any
adjustments.
● This adjustment must be
correct or accurate cuts can
not be made. Also inaccurate
adjustment can result in kickback
and serious personal injury.
. Remove the safety switch key and
unplug the saw.
2. Remove the blade guard for this
procedure but reinstall and realign
after adjustment.
3. Raise the blade to the highest
position and set at the 0° angle (90°
straight up).
4. Select and mark, with a felt tip
marker, a blade tooth having a "right
set" and rotate the blade so the
marked tooth is /2 in. above the
table.
5. Place the combination square
base () into the right side miter
gauge groove (2).
6. Adjust the rule so it touches the
front marked tooth and lock ruler
so it holds its position in the square
assembly.
7. Rotate the blade bringing the marked
tooth to the rear and about /2 in.
above the blade.
8. Carefully slide the combination
square to the rear until the ruler
touches the marked tooth.
9. If the ruler touches the marked
tooth at the front and rear position,
no adjustment is needed at this
time. If not or the base of the rule
is no longer parallel with the edge
of the miter gauge groove, perform
adjustment procedure described
in section ADDITIONAL BLADE
ADJUSTMENTS on page 27.
Fig. JJ
32
32
2
Hide quick links:
Advertisement
Table of Contents
