Other Problems - Miele T 8823 C Operating Instructions Manual

Other problems

Problem
The drying process
goes on too long or
even switches off.
Possible cause
In some circumstances, the
Clean out airways indicator
light still comes on, even
though the filters are clean.
Clean out airways.
Ventilation to and from the
dryer may be insufficient
(e.g. because it is installed
in a small room). This has
caused the temperature in
the room to rise sharply.
The vents below the door
are covered.
The fluff filters are clogged
with fluff or were still wet
when they were replaced.
Detergent residue, hair and
fine fluff can block the
condenser unit.
The laundry has not been
spun sufficiently.
The tumble dryer has been
overloaded.
Metallic components, e.g.
zippers have prevented the
dryer from registering the
correct moisture level.
Problem solving guide
Remedy
Please check all the
possible causes and
switch the dryer off and
then back on again.
Open a door or window
while the machine is in
operation for increased air
flow.
– Remove any fluff.
– Remove any fluff.
– The fluff filters need to
be dry.
The condenser unit should
be checked and cleaned
from time to time.
Make sure that your
laundry is thoroughly spun
at the appropriate spin
speed in the washing
machine.
Do not exceed the
maximum load for the
programme selected.
– Open the zippers next
time.
If the problem occurs
again, dry garments with
long zippers using the
Warm air programme
(timed drying).
37