Other Problems - Miele TKR850 WP S Operating Instructions Manual

Other problems

Problem
The drying process
goes on too long or
even switches off *
There are humming
noises
Cause and remedy
The room in which the dryer is located is too warm.
 Ventilate the room thoroughly.
Detergent residues, hair and fine fluff can clog the
filters.
 Clean the fluff filters and the plinth filter.
 Remove any visible fluff behind the panel in the
heat exchanger cavity (see "Cleaning and care -
Plinth filter").
The cool air intake (bottom right grille) is blocked.
 Move any objects, such as a laundry basket, away
from the dryer.
The fluff filters and the plinth filter were wet when
replaced.
 The fluff filters and the plinth filter must be dry.
The laundry is too damp.
 Spin using a higher spin speed in the washing
machine.
The tumble dryer has been overloaded
 Do not exceed the maximum load for the
programme selected.
Metal zips have prevented the dryer from registering
the correct moisture level.
 Open the zips next time.
 If the problem recurs, dry these items using the
Warm air timed drying programme.
* Before starting another programme:
 Switch the dryer off and then on again.
This is not a fault.
The compressor (heat pump) is operating or you have
selected the Steam smoothing programme.
 No action is required. These noises are quite
normal and can be heard when the compressor or
the condensed water pump is operating.
Problem solving guide
63