Table of Contents
Advertisement
Problem solving guide
Other problems
Problem
There are humming
noises.
A programme cannot be
started.
Only the Start/Add
laundry sensor flashes
slowly when the
programme is running.
The tumble dryer is
switched off.
The interior drum
lighting does not come
on.
56
Possible cause and remedy
The compressor is operating.
These noises are quite normal and do not indicate a
fault.
There is no obvious cause.
Connect the tumble dryer to the mains electricity
supply
Turn on the tumble dryer.
Close the door.
Check whether the mains fuse has tripped.
Has there been a power cut? When power is
restored, any previously running programme will
restart automatically.
Once the programme has been running for
10 minutes, the indicators go out. The Start/Add
laundry sensor flashes slowly. This is not a fault, but
a normal function to help save energy.
Touch a sensor to switch on the indicators.
See "Programmable functions", section " Control
panel standby status".
The tumble dryer switches off automatically after
15 minutes if no further selections are made. This is
not a fault, but a normal function.
Select a programme.
To save energy, the drum lighting goes out
automatically after a set time and after the
programme starts.
Switch the dryer off and then on again.
To switch the drum lighting on, open the door of
the tumble dryer.
The drum lighting is faulty.
The drum lighting is designed to last a long time and
should not normally need to be replaced.
If you have tried the remedies above but the drum
lighting still does not come on, please contact
Miele.
Advertisement
Table of Contents
