Brady Handi Quick Start Tutorial page 9

Defaults, Saving
File Key
(storing labels in memory)
This option lets you Save, Get, or Delete a file. There is a 10,000 byte
memory resident in the HandiMark
1. Type your name.
2. Press and release the 2nd key, wait a moment, then press the File key.
3. Name file: NAME. Press: Enter.
4. Press Clear
(use Defaults).
5. Press and release the 2nd key, wait a moment, then press the File key. Cursor
down to "Get". Press right cursor key until your file, NAME.OS, appears.
Press: Enter.
Note: If you have saved more than one file, you will need to use the left and right cursor keys to locate
the file name. Or, you can type the file name if you know it. You must use the .OS extension for files
saved in the operating system. Use the .PM extension for files saved in the pipe marker application.
6. The file you just created is retrieved.
7. Press Clear – see p. 9 of tutorial for explanation of this special clear
(use Defaults)
function.
The File function also lets you print a list of all the files stored in memory.
To do this:
1. Press and release the 2nd key, wait a moment, then press the File key.
2. Cursor down to Print File List. Press: Enter.
3. The list of files stored in memory prints, including their 2-letter extension.
Density
(print density)
Whenever a tape or ribbon is installed into the HandiMark
nominal print density setting. However, due to variations in printers and the
printing environment, it may be necessary to adjust the print density setting.
1. Press and release the 2nd key, wait a moment, then press the Density key.
2. Press the left or right cursor key once for each increment desired. The right cursor
key increases the print density and the left cursor key decreases it.
3. Press: Enter.
Note: the print density is reset to the nominal value when a new ribbon or tape is installed.
©2003 All Rights Reserved
® .
® , the system is set to its
"Label" Key
("next label" key)
Use to enter several different labels to print at the same time.
1. Type the following (check to be sure that Type Size is less then 0.4"):
Line 1: Type: Brady
Line 2: Type: USA
2. Press the Label Key
(2nd from the bottom row, 2nd in from the right)
3. Type the following:
Line 1: Type: HandiMark
Line 2: Type: Label Maker
4. Press: Print/Stop.
5. Do NOT clear.
Note: the "Area" Key ("next area" key) is a future feature of HandiMark
printer at this time.
Press: Enter
Screen will clear.
Press: Enter
® and is not operational on your
9