Oki B4500 Maintenance Manual page 56

LCD
Status level
Normal DL MSG
ACTIVE
Normal DL MSG
WRITING
Normal DL MSG
SUCCESS
- DL MODE
xxxx
Normal INITIAL-
IZING
Normal EEPROM
RESET'NG
Normal RAM CHK
********
IIIIIIII
Normal
IIIIIIII
Warning FLUSHING
(LOG)
I I
Warning
TONER LOW
I I
Warning
NON OEM TONER
DETECTED
I I
Warning
TONER REGIONAL
MISMATCH
I I
Warning
NON GENUINE TONER
I I
Warning
TONER EMPTY
I I
Warning
TONER SENSOR
I I
Warning
TONER NOT INSTALLED
I I
Warning
ORDER DRUM
I I
Warning
CHANGE DRUM
Warning INVALID
DATA
I I
Warning
ERR PSE
I I
Warning
tttt EMPTY
I I
Warning
TRAY2 COVER OPEN
I I
Warning
FILE SYSTEM IS FULL
43502101TH Rev.1
Table 5-1 (2/5)
LED
Varies The download Message data is being receiving.
Varies The download Message data is being writing.
Varies Writing the download message data succeeded.
Varies Downloading via NIC. The download status is indicated in the bottom line.
No Light Indicates that the controller side is initializing.
No Light Indicates that EEPROM is initializing.
No Light Indicates that the RAM is being checked.
No Light Displayed at power ON.
Blink Indicates that a job has been cancelled as the area storing logs
inside the printer has been drained and furthermore, a "cancel job"
instruction appears when logs are full.
Varies Toner amount is low. Exchange a toner cartridge.
or Blink
Varies The toner cartridge is not proper.
Install a proper toner cartridge.
Varies The toner cartridge is not proper.
Install a proper toner cartridge.
Varies The toner cartridge is not proper.
Install a proper toner cartridge.
Varies Toner near empty.
Exchange a toner cartridge.
Varies Something is wrong with the toner sensor.
Start a printer again. Exchange an image drum cartridge.
Varies A toner cartridge isn't being set.
Set a toner cartridge.
Varies The image drum is near life. Please do the exchange preparation of the
image drum and the toner cartridge, and exchange it.
Varies The image drum is over of life. Please do the exchange preparation of the
image drum and the toner cartridge, and exchange it.
Varies Received invalid data. Prompts the user to press ON-LINE switch
to clear Warning display. Displayed when the printer receives an
unsupported PDL command.
Blink Interpreter detects an error due to following reasons.
Data received after this is ignored till the end of the job.
When the job is received completely, this is automatically cleared.
- The job has a grammatical error.
- The page is complicated, and VM was used up.
Varies Tray tttt has run out of paper. Handled as Warning until the user
designates the tray that has run out of paper.
Varies Second Tray Cover Open. To continue, close cover.
Varies Flash Full has occurred. This is a transient warning.
Displayed until the job is completed, then, cleared.
Oki Data CONFIDENTIAL
Descroption
56 /