Ending An Ongoing Call; Ending Conference Calls; Ending Point-To-Point Calls; Ending Multisite Calls - TANDBERG MXP Series User Manual

MXP Series Video Endpoints
What's in this guide? Getting started

Ending an ongoing call

Y
ou end an ongoing call in the same
way as you do when using a mobile
phone— by pressing the red End Call
key on the remote control. This will
produce the Call menu.
Note! Switching off the monitor(s) using
the power on/off switch on the monitor
will not end an ongoing call. Some
systems even come with monitors that
cannot be switched off!

Ending conference calls

Ending a MultiSite call can only be done
by the host. The host is the party that
initiated the video conference.
The other parties can disconnect
themselves from the conference at any
time, but they have no influence on the
rest of the conference.
To end one or a few of the calls in a
MultiSite video conference, navigate to
the name of the call to be terminated
and terminate that specific connection
as if it were a simple point-to-point call.
D1479201 MXP Series User Guide, May 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
Making calls Making calls Using the phonebook
21
In-call features Videoconferencing
Ending point-to–point calls
Press the End Call key or the OK key on
the remote control...
This will cause the End Call dialog box
to be displayed...
Then press the End Call key or the OK
key on the remote control again...
User Guide
Contact us

Ending MultiSite calls

Press the End Call key or the OK key on
the remote control...
This will cause the End Call dialog box
to be displayed...
Then press the End Call key or the OK
key on the remote control again...
www.cisco.com