Handling Calls; Placing A Call; Answering A Call; Ending A Call - TANDBERG 1000 User Manual

Getting started

Handling Calls

Placing a Call

There are three ways to place a call:
A. Use the NewCall softbutton. A dialing tone is heard and the desired number can be entered. To delete a digit,
use the << soft-button. To cancel the number entry, use the EndCall softbutton or press D
required number of digits has been entered the call will proceed automatically.
B. Just start entering the number using the number keys. No dialing tone will be heard in this case. To delete a
digit use the <<. When the required number of digits has been entered press the Dial softbutton and the call
will proceed.
C. Press C . A dialing tone is heard and the desired number can be entered. To delete a digit, use the <<
ONNECT
soft-button. To cancel the number entry, use the EndCall softbutton or press D
number of digits has been entered the call will proceed automatically.
U C
NOTE SING THE ONNECT BUTTON ONLY WORKS FOR THE FIRST CALL MADE
HAVING ANOTHER CALL ON HOLD

Answering a Call

To answer a call, use the Answer softbutton or press C
connect

Ending a Call

disconnect
To end a call, use the EndCall softbutton or press D
TANDBERG 1000/550 for Cisco CallManager
.
. I
T WILL NOT WORK IF YOU ARE TRYING TO INITIATE A SECOND CALL WHILE
.
ONNECT
.
ISCONNECT
16
. When the
ISCONNECT
. When the required
ISCONNECT
O T1000 C
TIP
N FOR ISCO
C M
ALL ANAGER THE PUSHBUTTON AT
THE FRONT OF THE SYSTEM CAN BE
USED TO ANSWER