Table of Contents
Advertisement
MXP Series Video Endpoints
What's in this guide?
Getting started
Snapshots
When you are in a call with a system that does not support dual video stream
T
he system can take a snapshot of
your live video. Snapshot is handy
when you are in a call with a system
that does not support dual video
stream. Use the snapshot feature to
show a snapshot of your presentation
and continue the meeting with main
camera.
Your video system can send snapshots
in a point-to–point video meeting
only, sending snapshots in MultiSite
meetings is not supported.
The following should be observed:
• When displaying a snapshot, it will al-
ways be the latest snapshot taken that is
displayed, regardless of which end (near
or far) took it.
• Any snapshot taken is deleted once the
call is terminated.
• The snapshot feature uses H.261 Annex
D. Consequently it will fail to work when
using H.264 video compression.
Taking a snapshot using the remote
control
In a point-to-point call press the
*
Snapshot key (the
key).
If the Number Key Settings menu has
been set to Touch Tones, pressing the
Snapshot key will not be interpreted as
snapshot, but as a touch tone.
The Number Key Settings must have
been set to something else to make
the key work as a Snapshot key. This
is done in the Control Panel of your
D1479201 MXP Series User Guide, May 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
Making calls
system. Your system administrator may
have password protected this area.
Likewise, this will not work when you
are in an input field requiring numerical
*
or text entries. The
will then be
*
interpreted as just
.
Using the phonebook
In-call features
In-call features
Taking a snapshot using the menu...
In a call, press the OK key to produce
the main menu and navigate to the
Presentation icon...
Displaying a snapshot...
In a call press the OK key to
produce the menu line, if needed,
and navigate to the Presentation
icon...
44
User Guide
Videoconferencing
Contact us
... then press the OK key to display the
Presentation menu. Navigate to the
Snapshot tab and then down to the Take
New Snapshot icon. Press the OK key to
take a snapshot and send it to the far end.
... then do as above, but select Display
Snapshot instead. Press the OK key to
display the snapshot.
www.cisco.com
Advertisement
Table of Contents
