Table of Contents
Advertisement
INSTALLATION
This heater does not require a 120V A.C. supply for operation. In case of a power failure, the burner switch and the optional remote control/
thermostat will continue to operate. However, a 120V A.C. power supply is needed for the fan/blower operation.
Caution: Ensure that the wires do not touch any hot surfaces and are away from sharp edges.
NATURAL GAS
For
Thermocouple
Gas
In
"S.I.T" Valve
Electrical Grounding Instructions
This appliance is equipped with a three pronged (grounding) plug for your protection
against shock hazard and should be plugged directly into a properly grounded three-
prong receptacle. Do not cut or remove the grounding prong from this plug.
30
WIRING DIAGRAMS
Units and Units
Pilot
Assembly
In
White
Brown
Remote Transmitter
(Optional)
NOT
Equipped with DC Spark Boxes
Neutral
Live
120V AC
Minimum Convection
Air Temp. Switch
To
Thermocouple IN
Piezo
Ignitor
OFF
ON
Thermostat
Remote
(Optional)
Receiver
(Millivolt)
(Optional)
(Millivolt)
WARNING:
Green
Fan
Ground
Ground
ON
OFF
Red
Black
Rotary Speed
Control
Black
ON
Burner
OFF
Red
CAUTION:
Label all wires prior
to disconnection when servicing
controls. Wiring errors can cause
improper and dangerous operation.
U32-5 FPI Direct Vent Gas Insert
Black
Advertisement
Table of Contents
