Bypassing Sensor Inputs - Viper 500 ESP Installation Manual

Car security

Table of Contents

bypassing sensor inputs

There are times when you need to temporarily bypass all sensor inputs to the unit, such as when remote start-

ing the vehicle. Anytime an auxiliary channel output is used, all inputs are bypassed for 5 seconds. During the

5 second bypass period, ground can be supplied to the H1/6 Blue wire without triggering the unit. When the 5

second bypass period ends, if the unit sees ground on the H1/6 Blue wire, all trigger inputs except the door

trigger input will remain bypassed until 5 seconds after ground is removed from the BLUE wire. This can be done

using the status output of a 551T remote start unit as shown below:

Table of Contents

Show Quick Links

Table of Contents