Solid Surface Material - Four winns V458 Owner's Manual

Figure Q4: Port Lounge Table
Before teak can be given any coating, it must be
completely clean. Follow the manufacturer's directions
with regard to cleaning. Once cleaning has been
accomplished there are finishes that may be applied
such as teak oil (traditional), sealers, or varnishing.
Again, we recommending following the table manufac-
turer recommendations. Additional note: There are
numerous teak products on the market that may be
tried that will give you the look you desire. Your Four
Winns dealer can also provide you with some helpful
suggestions.
NOTICE
DO NOT use abrasive cleaners or sol vents on
cockpit table. DO NOT use Soft Scrub™ soap
or similar cleaning prod ucts; they will scratch
the surface and remove the shine.
NOTICE
DO NOT use tables as a cutting board. The
knife will leave gouges/marks in the surface of
the table. Use an actual cutting board in order
to protect the tables.
Q - 6 SOLID SURFACE MATERIAL
Solid surface material is utilized in the various coun-
tertops found in the galley, cockpit refreshment center,
port lounge, and heads. The solid surface gives these
countertops a rich look and makes for an extremely
strong yet lightweight top. It can be cleaned with hand
dish washing soap and water. Always read the label
before using any product. See Figures Q5 - Q9.
Woodwork and Composites - Section Q
Figure Q5: Galley Countertop
Figure Q6: Cockpit Refreshment Center
Figure Q7: Port Lounge Aft Countertop
Figure Q8: Aft Head Countertop
Owner's Manual Page 150