Table of Contents
Advertisement
The circuit breakers are labeled on the panels which
identify the component circuitry protected (Figures
H2-H5). These circuit breakers protect the designated
circuitry from damage caused by an overload or short
circuit.
NOTICE
Listed on the circuit breaker panels and cabin
electrical panels are various labels for the
circuit breakers protecting different component
circuitry. A particular label does not necessarily
mean your boat is equipped with this com-
ponent if either the component is optional or
not available to that particular model. Please
see your Four Winns dealer for details.
If a circuit breaker does trip, determine the cause of
the fault. Take the necessary steps to correct the
cause. Once the correction has been made reset the
circuit breaker.
Do not keep resetting a circuit breaker without
investigating the cause of the fault. Doing so
could lead to damage to component circuitry or
possible fire. Please see your authorized Four
Winns dealer should problem persist.
Note: The engines and drive units are fitted with
automatic circuit breakers. The circuit breakers cut the
power should the system be overloaded. Please see
engine operator's manual for specific information.
H - 3
BATTERY CHARGER
The battery charger is standard on the V458 models
and is located in engine compartment. See Figure H7.
Figure H7: Battery Charger Location
Electrical Systems - Section H
The batteries will be charged by the battery charg er
when the boat is connected to dockside power and
the SHORE circuit breakers and BATTERY CHAR-
GER circuit breaker are "ON". These breakers are
located on the AC cabin panel. See Figure H4. If a
generator is available and operating, it too will allow
the batteries to be charged by the battery charger
when the BATTERY CHARGER circuit breaker is
placed in the "ON" position. Note: On V458 models
with IPS the FWD BATTERY CHARGER
(if applicable) is not utilized.
Additional information on the battery charger can be
found in Section H-8B - 120 Volt AC Equipment in this
manual and refer to the manufacturer's literature
included with the owner's packet.
H - 4
SYSTEM VOLTAGE
On the DC cabin panel a voltmeter is installed. This
voltmeter allows one to monitor the condi tion of the
port engine, starboard engine or house battery. Place
the selector switch to the desired battery to be
checked and the volt age will be indicated on the
voltmeter. See Figures H5 and H8.
Figure H8: DC Cabin Panel - Voltmeter
It should be noted that the engine battery voltage may
also be checked using the respective EVC display.
Additional informa tion on voltage may be found in the
engine owner's manual.
Owner's Manual Page 73
Advertisement
Table of Contents
